IP Series Incubators provide solid build quality and reliable performance ideal for today’s busy and demanding laboratory.

Available in sizes from 60 to 250-litres and with a wide operating temperature range. The IP Incubator range can be supplied as either fan circulated or natural convection and both models have a choice of either Uni and Multi-program control systems.

The uni-program system offers single temperature selection and control at the push of a button. Multi-program controls will allow up to 8 multiple-step cycles to be stored in the memory at any one time, offering segment programming including ramps, dwells, stop and repeat functions.

Capacities: 60, 100, 150 and 250-litres
Temperature Range: 30°C to 80°C
Air Movement: Natural Convection and Fan Circulated options
Control System: Uni and Multi-program options

The IP Series of incubators offers maximum flexibility and unparalleled performance for the ever increasing demands of today’s laboratory.

Traditional quality and modern manufacturing techniques linked with LTE’s built-in reliability mean that the IP Series represents excellent value.

Flexibility

The IP Series is available in 4 sizes from 60 to 250 litres. Customers can then choose between fan circulated or natural convection options, plus there is a choice of PID control systems to suit most applications as detailed below:

“U” Models

This uni-program system offers single temperature selection and control at the push of a button. Following a mains power failure, the controller will automatically re-instate.

“M” Models

Our multi-program controller will allow upto 8 multiple-step cycles to be stored in the memory at any one time. It also incorporates a selectable temperature ramping function, which allows controlled temperature rise and fall rates to be programmed into a cycle. At the end of a program sequence, the controller can be programmed to stop or repeat the sequence again. The repeat function can be programmed for a specified number of repeats or it can repeat continuously until interrupted. Following a mains power failure, “M” models have 3 recovery options (cycle hold, start cycle from the beginning or re-start cycle from point of interruption).

RS232 or RS485 communication ports can be added to all “M” models.

All “M” models are fitted with an inner glass door as standard.

Performance

Fast heat-up times, almost undetectable overshoot and superb accuracy (see table below) make the IP Series a class-leading product.

All IP Series incubators incorporate a manual reset over-temperature cut-out, in line with IEC1010-2-010.

	Choice of heating element, heat can be generated by natural convection or can be fan circulated depending on model required.
The PID control system is located next to the door on the front of the unit and the digital display shows both the set temperature and the current temperature of the unit.
	A slot is fitted in the end of the spindle for setting the over temperature cut out. The reset button is immediately below and can only be reset after a fault when the temperature in the interior falls below its set point.
All our OP Ovens are coated in anti-bacterial epoxy powder coating which is designed to combat destructive microbes and to protect against the growth and migration of bacteria.
	The uni-program system offers single temperature selection and control at the push of a button. Multi-program controls will allow up to 8 multiple-step cycles to be stored in the memory at any one time, offering segment programming including ramps, dwells, stop and repeat functions