LEEC PL3 Plant Growth and Seed Germination Cabinets, With Stainless Steel Chamber Interior, 0 °C to +60 °C Temperature Range, 320 Litre Capacity
PL3 / SL3
Temperature Range* Lights OFF
0°C to +60°C
Temperature Range* Lights ON
+5°C to +60°C
Temperature Control Lights OFF
Temperature Variation Lights OFF
Via the control panel as standard the model quoted has fitted as standard a digital 24 hour timer to control the day/night cycle of lights on and off
(7 day optional)
White polyester powder coated steel
2 x 12mm
Expanded PU foam
1745 H mm
635 W mm
660 D mm
1275 H mm
510 W mm
490 D mm
* Temperature specification for models PL2 & SL2 at 20°C ambient
LEEC Plant Growth / Germination Cabinets are based upon the LEEC Precision cooled incubators. They have internal lighting, digital temperature cycling and digital light timers as standard to simulate day and night conditions.
LEEC Plant Growth Cabinets use the same microprocessor based digital temperature control system as the cooled incubators on which they are based. The temperature is cycled using a digital 24 hour timer as standard, or alternatively a 7 day digital timer can be specified for no extra cost. Digital over and under temperature protection and alarms are fitted as standard to all models. The chambers are fan assisted for optimum temperature performance and stability, which in turn provides reliable, accurate storage for samples.
All models are fitted with a digital 24 hour digital light timer to control the day / night light cycle. Each incubator door is fitted with a pair of white fluorescent tubes. These give a lighting intensity of approximately 3000 lux in the chamber. For higher lighting intensities and extra lights can be added. All lights are mounted vertically in the outer door. Each door is vented at the top and bottom to allow unwanted heat to escape from the light tubes. Plant Growth Cabinets fitted with four or more light tubes in each door also have a small extract fan in the door to help with heat removal. This helps to maintain stable temperature control, especially at lower chamber temperatures. The lowest temperature setpoint is slightly different when the lights are ON due to a small amount of heat that escapes from the lights into the chamber.
High Humidity Models
Two models (SL2 & SL3) have sealed, water tight chambers. These should be used when high levels of humidity are required inside the chamber, for wet sample storage or if /RH ultrasonic humidity control is required. Models SL2 and SL3 can also be factory fitted with the optional /RH ultrasonic humidity control system. This microprocessor controlled humidity system allows precise control of RH levels inside the chamber.
Temperature Range °C0°C to +60°C
Exterior FinishWhite Polyester Powder Coated Steel
Dimensions (mm)1745 x 635 x 660
Timers IncludedDigital 24 Hour