Jenway PFP7 Industrial Flame Photometer, supplied with Na, K, Ba, Ca and Li filters, connecting hoses and clips, compressor plug and drain trap (230V/ 50Hz)

Not rated yet
0

Technical Specification

 

ParameterPFP7
Range0 to 199.9ppm
Limits of detection Na0.2ppm
K0.2ppm
Li0.25ppm
Ca15ppm
Ba30ppm
Reproducibility<1% coefficient of variation for 20 consecutive samples using 10ppm Na set to read 50
Linearity< 2% error when 3ppm Na/K and 5ppm Li are set to read 100
Stability< 2% drift over 5min when continuously aspirating 10ppm sample set to 50.0. Specificity Interference from Na/K and Li equal in concentration to test element will be <0.5%
Recorder outputNominal 1.00V for a reading of 100.0
Electrical supply90-125V or 190-250V @50/60Hz
Air supplyMoisture and oil free, 6 litre/min @ 14psi
FuelPropane, butane, natural gas or LPG
Size (w x d x h)420 x 360 x 300mm
Weight8kg
  • £3199.35
Qty:  

PFP7 Industrial Flame Photometer

• Designed for industrial analysis
• Supplied with Na, K, Li, Ba and Ca filters
• Low temperature, single channel
• Flame failure safety system
• Operates with propane, butane, natural gas or LPG
• 3 year warranty

The PFP7 is a low temperature, single channel flame photometer that is designed for the routine determination of sodium, potassium, calcium, barium and lithium concentrations. The flame failure safety system makes these products ideal for use in industrial and educational environments. The use of fine and coarse sensitivity controls allows for accurate measurements each and every time.
    • SKU
      500701
  • Manufacturer
    Jenway (part of Cole Parmer)

The Jenway flame photometers are not supplied with the following accessories but some, e.g. the air compressor and gas regulators, are necessary to run the flame photometer. 

A water separator is recommended to remove any residual water from the compressed air supply. The size of water separator required depends on the local humidity. If there is high humidity then the large water separator is recommended.

Gas regulators are needed to regulate the pressure of fuel being inputted into the flame photometer.

A fuel filter is recommended to ensure that no particulates get into the mixing chamber from the fuel supply. 

To complement the Jenway range of flame photometers there are several calibration standards offered to enable accurate calibration of the flame photometer. All calibration standards are 500ml unless otherwise stated.

Ordering Information

Part CodeDescription
535 001Air compressor (230V/ 50/ 60Hz)
535 002Air compressor (110V/ 60Hz)
500 176Water separator (small)
500 177Water separator (large)
500 093Fuel filter
500 178Butane regulator
500 179Propane regulator
500 180Natural gas regulator

Calibration Standards

Part CodeDescription
025 0081.00mmol/l Li
025 004100mmol/l Na, 100mmol/l K
025 006140mmol/l Na, 5mmol/l K
025 007120mmol/l Na, 2mmol/l K
025 005160mmol/l Na, 8mmol/l K
025 027160mmol/l Na, 80mmol/l K
025 0211000ppm Na
025 0231000ppm K
025 0241000ppm Li
025 0253000ppm Ba
025 0091000ppm Ca
025 171Cleaning solution (1 litre)


Miscellaneous

Part CodeDescription
500 134Dust cover
500 019Nebuliser